Quote:
Originally Posted by drm916
Overall mine fit great. But it was a little too tight with that little piece on there. It was the bottom one on my ducting. The side one was able to stay on.
I removed the passenger side fender liner to better see what was holding me up.
Last but not least you could test fit it by removing the passenger side fog light and brackets and see if it then fits. If it does then you know for sure its related to that and you can plan your course of action.
But overall once I removed that rubber seal the bumper fit 99.9%. Next time I have my bumper off (new grills, headlight restoration front camera wire rerouting and secondary oil cooler addition), I am going to try moving around the factory oil cooler by loosening the bolts. Then try and see if I can get that rubber seal back on. I have a feeling I probably can. It was that close on my car.
|
This work perfectly, it was the oil cooler duct! I just have to re-adjust the oil cooler duct lower. After that, it fit like a glove
. It can fit with the rubber seal also. Thanks a lot!