|
If you use FRM2 for LCI xenons you need to turn off a few parameteres in NFRM using NCS exper. Unless you didn't have Xenon ligts before, then you have to add $522 to FRM and CAS using FA write (VO write) and recode these modules.
If you had FRM1 and you replaced it with FRM2, you have to programm this module and change VIN using WinKfp, then you have to add all VOs to FRM2 these same as are in CAS (you have to compare both), additionaly you have to add to CAS and FRM2 this date #0307 and remove the old one. Then you have to recode these two modules and all should be fine.
|