Quote:
Originally Posted by Craig@SupremePower
i see plenty of pics but no close ups of how these installers are dealing with the strip on either side that the ski rack access panels pop up...any close up shots?? TIA... considering doing this and obviously want it perfect as well as not being a fan of it unless its done from outer edge to outer edge!!
|
I've since changed directions with my mods and removed it. It really wasn't too bad though. Here's the order in which I did the steps:
-start with a large
single piece of vinyl enough to cover the entire roof (doesn't need to be exact, but the closer the better).
-spray and apply front of the car---> back
-cutout shark fin area
-apply vinyl around shark fin area
*After applying the whole overlay the adhesive began to back off the rubber moldings along the sides. At that point i made cuts in between the molding and tucked the vinyl underneath. Finally I cut the slots for the rack. Take your time and be patient, I can't stress this enough. You'll probably be re-aligning the piece since its so large, make sure to have extra bottles of soapy water.
Best of luck.