Quote:
|
Originally Posted by halw540
Hope I am not out of line with this related question given the thread history.
I have a set of power seats out of a '07 E9x going into a custom application. The passenger's side works fine with just +12 volts and ground wired per this thread. The drivers seat will adjust (front/rear, tilt, height) as long as I keep changing settings after power is applied. However the seat stops adjusting if power is left on for maybe 15 seconds if no adjustments are made. Remove power, wait a couple of minutes and it will adjust with the same results as above. The seat has memory and heated bottom/back that I have no interest in getting functional.
I have swapped out both the seat switch assembly and seat controller getting the same results.
The driver's incoming connector is poputated, and I have wired, as follows:
Pin
2) K_can_H I have not wired
3) K_can_L I have not wired
4) +12 volts wired
8) ground wired
14) thru 19) I have not wired
Obviously a great deal of research went into this thread. Perhaps what I am experiencing makes sense to someone. Help would be appreciated and thanks in advance. Hal
|
You must connect the driver seat on the kcan. We all got the same problem and fix.
Cheers