Quote:
Originally Posted by bigpapapablo
can anyone write up a DIY for installing an aftermarket headunit?
I would love to have that JVC in my car. small single single din headunit with navigation built in......
how would one go about replacing the headunit? is it just a matter of a wiring harness and getting the radio out?
thanks
|
Just get the wiring harness and dash kit from Scosche or metra and you need to pull the constant 12V from the battery. Just verify the pins on the wiring harness with this...
Radio Harness
Pin#
1 REAR RIGHT SPEAKER +
2 FRONT RIGHT SPEAKER +
3 FRONT LEFT SPEAKER +
4 REAR LEFT SPEAKER +
5 REAR RIGHT SPEAKER -
6 FRONT RIGHT SPEAKER -
7 FRONT LEFT SPEAKER -
8 REAR LEFT SPEAKER -
9 CAN Low
10 Empty
11 CAN high
12 GROUND
13 Antenna (remote turn on)
14 Illumination
15 +12V constant (not constant-get it from the battery)
16 Empty