Hi Guys,
I am wanting to install some HID Reverse lights.
There are kits that can be installed that prevent warning messages which are $200 (a little much just for a reverse light)... But this is the kit i am going to purchase... Cheap, Yes... but if coding can iron out the errors, then why spend more?
http://www.ebay.co.uk/itm/35W-12V-H3...ht_4586wt_1265
H3 bulbs are supposedly whats needed to fit inside the reverse housing...
Anyway... obviously these are going to throw codes... So would removing the Reverse light start up and anything else required allow these to work without any problems?
I am completely new to coding, and i would be getting my garage to do it, so all detailed help is needed and very much appreciated!)
I am guessing this would be a similar process if you wanted to run an HID Fog light kit?
Many Thanks
Josh