Just to dig this thread up from the depths...
Could anyone potentially shed some light on the following that I haven't seen covered?
Upgrading from LCI Manual Sport Seats, to LCI Partial Electric Sport Seats with Heat.
There is no need for K_CAN, so I have run an additional power, ground, PWM signal to the JBE and the additional small gauge wire into the fusebox at X11001 position 10 - to each seat.
So my car-loom looks like so;
However, when the new seats arrived, there is a pin in pin 9 on both seat connectors - something my car-side loom does not have.
The seat connector looks like so;
I'm going to run this in properly, back to the fusebox - but does anyone know what fuses I'm needing to plumb in?
I have added fuses in 45/46 for what I believe is the seat heating modules (no seat modules on these seats).
I cannot find any information about this - most retrofits need the car-side connector re-pinning from 9 to 4, not an additional in 9.
Ideally I don't want to use tap connectors, I'm going to wire it in to the fusebox, as the car will be in pieces anyway.
Any advice would be great