Valve Cover
I'm not sure if this is the correct forum, but I'll take my chances.
I just removed my valve cover and intake manifold for basic maintenance.... and to do the poor mans intake valve cleaning.... Sea Foam, a huge mess and brass brushes. My gasket set comes in on Tuesday. Aside from the obvious steps to replacing the covers, Are there any secret tips, advice, etc. I should beware of before I attempt the install? This is my first go around doing this, so I don't want to shoot myself in the foot by forgetting a step, or doing something incorrectly.
Again, I apologize if this post is in the wrong location, so please bare with me.
Thanks.
|