|
oh oh oh... let the foggy nites begin! 10 minutes tops to complete this diy. I used a butter knife to pry the trim off. inserted into the steering wheel side and then turned the knife sideways which elevated the trim. Pried slightly until the door side trim started to lift a bit, then inserted the butter knife on that side an pried up a bit. The light switch part came out easily. The trim went back into place with ease. Tested. True.
By the way, you can turn on the rear fogs without turning in the front. I'm gonna go out and blind some F*ckers tonite! Just kidding. I will use my rear foglights appropriately and safely... I promise.
By the way, when inserting the new switch into the trim, if you lift the rear end of the clip it clicks in place easily.
__________________
"Teach the ignorant. Ignore the stupid."
|