So , my point about using split system is valid and make sense ?
I was thinking of using the WW to store water for cleaning/cooling/comp purpose.
And install the water/meth kit in the trunk.
If possible controller will be set up to run pump#1 (WW water) at low PSI range.
And as a stage 2 , controller will use pump#2 to spray from water/meth tank in trunk.
Alternatively, also a stage 3 can be used if it is necessary with bigger nozzles at max PSI.
Found movies and info regarding meth and cleaner valves , its not working at all.
But I have still to see cleaned valves/intakes after water/meth kit installed , if they stay clean.
Additives for cleaner valves/intakes exist , so maybe they could be added in WW for cleaning purpose.Just a thought.
And any input on what minimum PSI that is safe to start adding water , just water?
And what nozzle should I use?
|