Quote:
Originally Posted by 2blu4u
id keep an eye on it but the way I did it is took the last fuel line off toward the rear of the car, pulled the hose that goes into the valve cover and there is a circular cover that you can either use a 14mm wrench or a 1/2in either works fine. once the cover is off it takes a little maneuvering to get the valve out. follow the link
http://www.n54tech.com/forums/showpo...&postcount=190
for pics. its relatively easy just don't dick up any plastic pieces haha! oh and it may be time to clean your intake valves as well if you haven't done that already. oh and VCG is (Valve Cover Gasket)
|
ok thanks, when I was on the RB Turbo site they offer a PCV Upgrade accessories, which one should I get?
http://www.rbturbo.com/products/acce...e-screw-on-cap
http://www.rbturbo.com/products/accessories/rbpcv
http://www.rbturbo.com/products/acce...-pcv-vent-hose