E90 325i misfire cylinder 1
Hello all,
I am a longtime viewer, but I don't comment very often. I could use some help though. My car is misfiring in cylinder one with the following code:
29CD:
29CD misfirings, cylinder 1
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Signal or value below threshold
Freeze Frame Information
Event 1Odometer 135832kms 84402miles
Engine temperature 49.50 °C
maximum rpm at missfire 1,600.00 rpm
maximum relative load at missfire 58.98 %
minimum relative load at missfire 32.81 %
Event 2Odometer 135832kms 84402miles
Engine temperature 26.25 °C
maximum rpm at missfire 2,048.00 rpm
maximum relative load at missfire 82.03 %
minimum relative load at missfire 31.25 %
Event 3Odometer 135832kms 84402miles
Engine temperature 37.50 °C
maximum rpm at missfire 1,440.00 rpm
maximum relative load at missfire 99.61 %
minimum relative load at missfire 43.75 %
The vehicle has approximately 88k miles and has not had any engine repair, just basic oil/filter changes. The engine is running very rough, but came on suddenly. I drove the car a few miles in the morning, a few hours later when I restarted the car, this occured. I have restarted it a few times during the last few days to see if it would correct itself, but to no avail.
I have a bavarian technic cable that I have connected to my laptop in order to pull the code. This software can do some wonderful things, I just don't have a clue how to do them. Can anyone give me some recommended steps to resolve the problem?
Andre'
|