Quote:
Originally Posted by robc1976
When lowering raising car I m sure you have to adjust the struts via the collars. Am I correct in saying when the car is on jack stands with wheels off (no load on suspension) that the rear springs perches (where you adjust) be a bit loose so you can adjust them...not real tight? Basically I had one of springs a bit loose (tried springs without spacers) and the BC BR vendor said since the springs are a bit loose tighten up the strut so there is a bit more tension, but not so much you can't adjust them. My question is, I raised my car via spacers so should I raise the strut until the springs are a bit loose then tighten to have just a bit more tension like the vendor suggested? What s the protocol on the strut adjustments, didn't find much searching.
|
Hey Rob did you ever figure this out just installed these and was wondering the same? Help please.