|
Nice write up, I plan to do this valve cover gasket replacement soon, and have a couple questions…
1) where is the PCV located in the engine.
2) Do you have to move aside the ecu wire harness to get clearance of the top left corner (saw the video on this thread and wondering if its the same as in the 328 example)
3)after disconnecting the battery, fuel lines, sensors, will there be any codes that need to be reset/cleared or should everything start up without any codes on the dash.
4) any special tools that makes life so much easier during this install (such as special sockets, extensions, etc..)
Thanks again for posting this DIY, really helps getting another set of instructions besides the manual
|