Quote:
Originally Posted by poopdeckpappy
I installed my v1 today and it took less than thirty minutes. The most important tool is a good plastic, tapered antenna install tool. I never removed the trim. I followed the windshield / headliner to the A piller. Then used the trim joint, at the top of the A piller, to slip the wire around to the door gasket / seal. Followed the seal to the spot shown in picture 12. The entire cabin wire run was done with no trim removed. Just a tool to slip the wire behind the trim. Once inside this side panel the wire goes up over the glove box and drops right down into the fuse box area, behind the glove box.
Thank you very much for the fuse tap method. Nothing could be easier or less invasive, no wires cut, vamped or touched. I used slot 8 as well. This is the first DIY that didn't cost me more in repairs than money saved. This forum is great.
|
Do you have a picture of the
"good plastic, tapered antenna install tool" ?