Quote:
Originally Posted by ************
BEFORE YOU DO THIS PROCESS MAKE SURE YOU HAVE YOUR BLINKERS SET TO 3BLINKS . THEN FOLLOW THIS PROCCESS THEN.
for those of you stilll having issues on how to change this on FRM (frm1) the value that you need to look for in your nettodat file is different than on frm2(nfrm)
below imma post a poc of the value you need to change:
instructions are simple
AS USUAL:
1. open ncs
2. load profile
3.press f1
4.press f3
5.choose chassins (e89)
6.press back
7.read ecu (Frm)
8. after you see the screen with bunch of numbers pop up just close it
9.now go to your work folder.
10.open your nettodat.trc file and look for this line:
B 00340300
now look at the picture im about to post and see which value i changed to BB( 6 blinks).. before it used to be 2F=3blinks so iu changed to (BB)
after you change it
11.save file as NEttodat.man (make sure you select all files otherwise it would save as plain text.
now go back to your ncsexpert and hit BAsic functions
select coapiCodeSgByNettoData click ok
now a window should pop up :
the first line should show :Frm.xxx.xx
the second line its blank and you need to input this: NETTODAT.MAN then click ok.. it shoud run its process then if succesfully coded you will see a screen saying BAsic Functions ended Properly..
at this point youre done..
remove key from slot put back in then try your signal blinkers  |
Joe i followed each step but it didnt work. However, because i have comfort access I did not have the key inserted when coding, is it necessary to have the key inserted while coding the car?