Quote:
Originally Posted by torifile
All installed. I got the cover off without too much of a problem, but I could not get the rear left screw back in. Not sure what is going on there. It just won't get threaded for some reason. Not a big deal as the other 4 went back in just fine.
I zipped tied it and I think it's all good. Do I need to be concerned about heat near the wire connectors? They're just sitting on the engine block there. Seems like a less than ideal place for them. And where the heck is the adjustment dial? I couldn't find it anywhere.
|
You need a small screwdriver to open the JBD. It's a little potentiometer inside. You can adjust it however you like and then turn it down if you get any codes. Hopefully you have a scan tool or the tool that BMS sells.