BMW 3-Series (E90 E92) Forum - View Single Post - Broken angel eye ring **UPDATED** with DIY opening headlight and LED angel rings

3X3=5 · 10-06-2010, 12:52 PM

********* - good point about the possibility of breakage. Nothing would suck worse than having it fall apart inside the headlight after I hit a pot hole... Also you can see a little bit where the glue is at the bottom - it illuminates white rather than clear. I put the lights back on the car to test the light output and the undamaged side is a little brighter. Not much, but it's noticeable and it would bother me. Pics below (note the new ETS front mount!)

So I'm stuck replacing them for sure. I just spoke with Umnitza about their kit and it does look damn good. Guess I'll have to go that route and be even happier with my angel eyes!

PICS - Broken angel eyes on left.

10-06-2010, 12:52 PM	#7
3X3=5 Lieutenant 117 Rep 557 Posts Drives: in a lot of traffic Join Date: Jul 2010 Location: Seattle iTrader: (8)	********* - good point about the possibility of breakage. Nothing would suck worse than having it fall apart inside the headlight after I hit a pot hole... Also you can see a little bit where the glue is at the bottom - it illuminates white rather than clear. I put the lights back on the car to test the light output and the undamaged side is a little brighter. Not much, but it's noticeable and it would bother me. Pics below (note the new ETS front mount!) So I'm stuck replacing them for sure. I just spoke with Umnitza about their kit and it does look damn good. Guess I'll have to go that route and be even happier with my angel eyes! PICS - Broken angel eyes on left. Attached Images Last edited by 3X3=5; 10-06-2010 at 01:25 PM..
	Appreciate 0 Quote