Quote:
Originally Posted by nukezero
I finally got it to work. Somehow, the light is supposed to go off and then if I retry again, it would read and get the injector values.
Next question. Why is it that when I change the flow rate say to 2.18 , it shows me 2.16. Then when I put 2.19 it becomes 2.17. I have to put some offset to get the value to appear correct. What the heck is going on?
I played around with the values and when I rewrote the same values, that's when I noticed it applied the offset. I had to apply my own offset to offset that offset if that makes any sense.
|
NO! Do not mess with the values. The DME will automatically recalculate those values once you enter them. Sometimes it will round the numbers up, sometimes it will round them down. Don't try to fool the DME into accepting exactly what's written on the injector.