|
Thanks for everyone's comments.
Shiv - there was a 10 amp and 50 amp fuse available. Your video said to use the 40 amp if possible, or then the 50 amp. I was concerned that the 10 amp fuse would have it's load exceeded and trip, so I opted for the 50 amp. BTW Dustin emailed a brief question which I replied and am waiting to hear back.
Drove the car 20 miles today on two trips without any Check engine lights. Also in two starts today did not see the heavy battery drain message on start up.
BTW I have version 1.47 per documentation.
Car starts right up - no problem there. When I installed the vacuum lines I was very careful but I will check anyway.
To Itsbrokeagain - I may take you up on your offer to help scan - LI is not the far and we all know what lengths we will go through when we get desparate. I didn't realize that the OBD scanner wouldn't read the codes - isn't it the law that it should? Maybe these are special codes not covered by the law?
|