Quote:
Originally Posted by stuta
Quote:
Originally Posted by hardr85
I was searching and saw my post, I had forgotten about. I did get it to work a while back. I wanted to make sure and do a follow up for anyone who is in the same boat, and just starting like I was back then.
What I didnt realize then is that after changing the VO in the CAS and FRM, I needed to code the entire car for the changed VO's to become effective. A lot of the information out there does not mention that step.
|
hello there
can you please lay down all the necessary steps needed to change VO so as to get rid of the traction control, abs and dsc warning lights on the dash.
i changed my e90 06' 330d dde and cas which works fine but am stuck with these lights.
i have ncs expert but need guide lines on how to code/change the dde and cas VO to match my cars' and get rid of the lights.
i have inpa, ncs expert, winkfp and all....i am a diy guy but am scared i will fry my car if i simply jump into coding without the correct guide. thanks in advance |
You should copy your VO to the new CAS from your FRM.
Load the FRM VO in NCS Expert. Then FA_WRITE CAS module.
Then default code CAS and DDE with expert/factory mode profile and SG_CODIEREN