Quote:
Originally Posted by Rotary Rasp
Thanks, I'll give that a shot.
I am able to read the NFRM module without any problems. I don't get any errors until I reach the last step and try to execute the job (F3). Is that the same problem you were having?
|
Hmm, no it isn't. I didn't test that far because there was nothing there I wanted to code. Any errors I encountered were when I first clicked Process ECU and selected a particular module, and I believe NFRM was one of them. In that case I'm not quite sure what to tell you. Just to be sure though, you're clicking NFRM after clicking the Process ECU button, right, not at the initial selection screen where your only options are CAS, FRM, and NFRM? For that one you should always be clicking CAS as far as I can tell.