View Single Post
      01-11-2010, 04:58 AM   #41
Former_Boosted_IS
Major General
306
Rep
5,175
Posts

Drives: 4 Wheels
Join Date: Aug 2007
Location: Planet Earth!

iTrader: (15)

Quote:
Originally Posted by shoes View Post
Unfortunately this stuff is a bit over my head and the install looks quite complex for a novice.
Please bear with me...

Basically, is this possible:
-On/Off switch for meth.
-Switch off: JB3 switches to Map 3, Meth deactivated
-Switch on: JB3 switches to Map 7(?), Meth activated
-If switched on, JB3 switched to Map 3 and meth deactivated if meth stops flowing.

Ideally I would want to be able to do this on-the-fly via the switch. Is this possible and what would I need to do this?
Would the "basic meth kit" suffice or do I need a kit with the CMGS?

(Sorry for derailing your topic somewhat whn, but I assume this information will benefit you as well. )

I would not suggest you going this route and the logs from cn555ic support my hypothesis. If you base map switch on power going to the pump, then you will run lean for a short period before the methanol kicks in if you are running a Procede. On the JB3 it shouldn't be a problem because they are not leaning out the maps as much as Procede. You need to map switch based on a flow gauge only. Snow SafeInjection will do this with their new unit that will be available in a couple of weeks. It is cheap and easy to install. CM and Labonte also has a unit that will do this.
Appreciate 0