1. Typically local race gear shops carry it, both shops near my loc always have it in stock (~$15 per bottle)
2. I buy 4 x 1Gallon jugs of distilled water, more than enough.
3. I'd be interested to see if that works. Like Chowbow said you need to drop the FMIC to get to the drain but there has to be another place to tap in (other than the small reservoir line), I'll have a look at realoem later today.
Quote:
Originally Posted by dsbj
Hey all,
Going to Infineon Saturday and have a few questions...
1) I haven't found MoCool anywhere local. I know Amazon carries it but I waited too long to order through them. Where do you pick it up normally? How about Water Wetter?
2) What is the radiator capacity? I want to know before I run my Distilled Water / Mocool mix.
3) I haven't seen any DIY on a radiator flush. So, I'm thinking about using my Mityvac 7201 Fluid Evacuator (link below). Do you think I can access the fluid through the reservoir? If not, how else do I flush it?
http://www.amazon.com/Mityvac-7201-F...9233290&sr=1-2
PS, Peter rocks!
|