Quote:
Originally Posted by Grant@DetailAddict
That error wont tell you anything. When it pops up close it the under View go to Error Log.
You may just need to code each module one by one in expert mode. That's the equivalent.
NO the empty MAN file is the worst way. Do it the right way.
|
Ok I left my car on a trickle charger since my last coding session had it down to 12.3V. I tried to process the car again, just to see the error log and which module it got hung up on. The message from the error log is as follows:
ERROR! Modul: LFCDHDIA.CPP (A_CASK.IPS/IPO), Proc: CDHapiResultText, LineNr: 01, ErrorNr: 2000
COAPI-2000: EDIABAS or SGBD error
SYS-0008: JOB NOT FOUND
>>> ERROR! Modul: COAPI2.CPP, Proc: coapiRunCabd, LineNR: 06, ErrorNR: 2000
SG_CODIEREN
The module NCS was coding when I recieved the error was CTUNE.
I havent tried coding each module one by one yet, I am waiting for a near full battery. I have a feeling it will more than likely just get hung up again on the CTUNE module.
Any Ideas?