Quote:
Originally Posted by demented328
Also had to bend the clips for the bulb holder. Haven't figured out a back cover cap but doesn't look hard.
|
Everything is pretty much back together with the exception of the lens cover. Will put that on once I make sure everything is good. For the back, I got this rubber end cap from The Home Depot
Cut the top off the Depo cap
Glued the rubber cap on to the original depo cap I just cut
Glued a length of bike tire rubber innertube on to the top of the cap I cut off and then glued that on to the original depo cap+rubber cap
Will zip tie the rubber innertube to seal that end once I run the wires through after everything is mounted. Gives enough extra space to clear everything, without being too big.