hey! if you have the exact same problem to the same code...try review over the install video and check to make sure that boost signal wire is in the right spot. i know this out of experience when uninstalling v2 to put V3 on a car.
it freaken boggled my mind every time i tried to start the car. then i traced my steps and found i accidentally put the yellow wire(i believe its yellow) in the wrong space(after 2hrs of scratching my head). i refused trying to call shiv or emailing him while i was figuring this out because i knew i would be wasting his time since i had a feeling i ducked up.
but after putting it back in the right spot, the engine light went away but i cant clear the code with the c-reader. every time i connect it, the code is there.
again...its very very easy to mess up that one, i strongly recommend you go over it all. it wont take long. :-)
|