Quote:
Originally Posted by crashoverride
I just did LEDs a couple weeks ago such a bitch big fingers and all. I ended up using pliers to pull straight down and out the bulbs.
However tonight my hard wired detector wire came loose so I had to open up and get behind. The clips are such a bitch. Spent a few hours trying to get clips to pop open in installing the LEDs with no success despite originally installing the hardwire harness.
But then pure inspiration hit me. The clips holding the lights and panel are on the front just on the other side of the map lights if you remove the frosted cover and map light lenses you can see the silver clips through the holes.... If I could just pull them towards back of car..... So I bent a nail a quarter of an inch fished it through pulled back on clip and was looking at back of lights in thirty seconds to get in and release both clips
|
Hey Crash... thanks for the info.
Just curious, why didn't you go the route of taking off the sunvisor clips?
Can you describe this a little more and do you think its easier than taking off the sunvisor clips: "So I bent a nail a quarter of an inch fished it through pulled back on clip and was looking at back of lights in thirty seconds to get in and release both clips"