Okay, got everything soldered on yesterday after work, just tested and P1057 fault fixed, however I'm in the beginning testing phase and have a P1030 fault now that is similar to the valvetronic motor, it says pending on the code reader... vehicle is running fine at idle. I think there may be something small that needs cleaned up on the board because final Ohms reading on this circuit (2 terminal/2 wires to motor) reads 6.55K ohms vs my good unit comparison of 6.56K ohms. This slight difference in ohms might indicate I still have a slight issue, however I'm not "Hard" coded. First thing I'm going to try now is the Full battery reset that X-Drive mentioned earlier on in this post.