Quote:
Originally Posted by igorbmwx5
Hi kaigoss69. I have purchased mObridge M1000-M-DA2 for my 09 X5 E70 with, currently, logic 7 (factory) amp, which I am planning to replace with aftermarket McIntosh amps. In any case, could you please send me connection diagram and all recommended voltages. I understand that red (+12V), black (-), what about the blue wire? What voltage (+?). I was trying to update the firmware on it and set it up for my BMW X5; however, I was not able to connect to the unit. Error message appears that most likely there is no power to the unit. What I did, I connected +12V to the red and (-) to the black (from my computer's DC power supply output). Do you think that the problem is with blue wire not connected to anything ??? Thank you in advance.
|
Blue wire is usually remote wire.
You should be connecting it to your car electrical system and not your laptop power cable. Some / most laptops work on 9 volts which will be less for DA2.
__________________
F36 Xdrive for her - HUD, park assist, heated steering wheel, rear camera, Apple car play
F36 RWD for him - HK, M sports pack, GTS tail light, Apple car play