Quote:
Originally Posted by efunroom
Not sure how to make the concealed case in the pic. any ideas?
|
Quote:
Originally Posted by Biff Trout
Mount for remote display (RD) and fairing for back end of V1 (to cover display and volume control) were fab'd out of 1" PVC sheet. The stock RD case has been cut down from approx. 1" deep to 0.5" deep to eliminate interference with the auto-rise steering column. The modular socket on the RD was removed and 4 conducter flat cable was soldered directly to the RD's circuit board and potted with dielectric epoxy. Also, the red arrow were buffed with 0000 Scotchbrite to a matte finish to eliminate reflective glare.
|
I don't smoke, so I'm planning on converting the sunglass holder to a control panel for my electronic countermeasures. I'll post pictures whenever I get it done.
This is how I did it on my Acura. The V1 display replaced the flocked plastic "Not An Ashtray" change bin. The red buttons are "kill" switches.
__________________
E91 6MT Alpine, Terra, Xenons, ZSP, ZCW, ZPP, PDC, CA, alarm, M shifter and M brake handle, Euro rear fog light switch, Euro aspheric mirrors, rear power outlets, Garmin nüvi custom cupholder mount, Lidatek, V-1 built-in remote display, tire pump, jack, floor mats.