|
Great write up. Literally took me 15 minutes from the time I got out the 1/4 inch ratchet, torx bit, and 3" extension. I needed no other tools. So nice to not have a worn trim piece any more. Thanks!
I switched out the original 335 for the Msport trim. I'm 6MT so no paddle shifters. Not sure if that is why this was so easy or not. To the poster above me, not sure why your buttons are not working, I did not disconnect the wiring going to the buttons, just unscrewed the one screw per side to get the button group off the trim, and then screwed it back on the new trim.
|