JB3 v1.1 Dyno
Conditions: 68.9 deg F, 29.4 in-Hg
Humidity: 6% -> This seemed kind of low.
STD: 1.01
Dyno run was done in Livermore, CA at Modacar with one single fan at the IC. No fan was pointed at the intakes. Car has DCI and I pumped about 9 gallons of 100 octane right before the runs. I didn't have a chance to do any WOT runs prior to the dyno run though. So it slowly adapted after the 3 runs as the graphs and numbers will show. This is my baseline before I put on an FMIC and power kept on creeping up the more runs we did. I think with enough runs, I would've made 350+ whp.
3rd and last run (best) was:
349.7 WHP
359.0 WTQ
2nd run:
345.2 WHP
356.73 WTQ
1st run:
342.3 WHP
349.5 WTQ
On a side note, the Dynolicious App calculated 346 whp...pretty darn close! Also the speed hit close to 150 mph in 4th but the dyno measured 135 mph.
|