I'm preparing to take my car in for diagnostics. I was powering through an on ramp earlier today and the limp mode indicator came on. Using the BC stalk I found that a CC-ID 29 was present.
I am going to remove the JB3 installed tomorrow, but I'm pretty confused about how to use the Bavarian Technic / BT cable.
As I understand the procedure is as follows:
- Plug in cable to USB port
- Plug in other end to OBDII
- Start up the software, walk through the menu items
I'm also not clear on what modules to clear. I have faults on the engine module, none present for fuel system (possibly not HPFP issue?). Codes:
Engine Fault
- 2C31
- 2C6A
- 30FF
CAS
- A10A
- A0B1
- A118
- A0B5
Instrument Cluster
- A3AD
- A3AE
- A554
I'm having a tough time googling what codes to trash ahead of the visit.
Edit: Found a BT code list, going to note what codes I find and flip through this spread sheet.