|
I rechecked all connections and sensors including power, CAN, and ground. They were all fine. The JB4 doesn't connect to the interface now either. I also added the flexfuel wires to the harness, its possible that there may be a loose connection there, but that doesn't explain why the JB4 doesn't communicate with the interface now when it did yesterday. My only guess is that it has something to do with during the cutting of the diode.
Currently running stock and will recheck the board and attempt to reinstall JB4 ISO after some more research.
Any thoughts guys? Should I try buying a new diode and running stage 2 again?
|