Quote:
Originally Posted by dmurray14
Which did you buy? Most will work, you just need to change the pin.
|
Not sure what you mean by changing the pin. I have soldered a pin into position #8, however I am still getting the same error. The pin is a little thinner than the others, so it I need to test if it is making contact.
Would soldering pin 7&8 togther work? Although it should work now that there is a pin connected to #8
- the cable I have is the one off e-bay ($119), "K + DCAN USB Interface (INPA Compatible)", with a clear plastic OBD connector