I'm going to fill in some things that weren't 100% clear to me when just reading through until getting underneath.
Step 7, undo the 16mm and reverse Torx which is on the steering mount. This isn't the rubber hose line bracket. I didn't understand the pictures until I realized this part of it. So anyone who is skimming the guide before hand, the reverse torx(E12) is just a multi-point 10mm socket with a 16mm wrench or ratchet on the back. Hold the 16mm firm, and turn the 10mm on the bottom.
Also, I had a problem removing the rubber bracket because it would spin with the nut. I just used vice grips to grab right above the nut since there is a hex piece that is barely gripable to hold it steady while you remove the nut.
Last edited by klipseracer; 04-13-2010 at 10:27 PM..
|