View Single Post
      11-06-2010, 05:51 PM   #49
OpenFlash
United_States
1733
Rep
17,960
Posts

Drives: A Lot
Join Date: Sep 2006
Location: SF Bay, CA

iTrader: (0)

Garage List
Quote:
Originally Posted by enrita View Post
Ok so i could just connect that EGT signal to the procede and read it?
Basically there is nothing to do on the firmware side?
Since i will put high flow cats in 2 weeks i could weld the bung than.
There's really not any update required in the firmware if you want to feed a standard 0-5 volt signal in the Procede. Just a couple small changes to the logging setup which I can describe via email.

shiv
Appreciate 0