|
^^^ exactly, you are only using one side of the harness to connect to the OEM connector at the OEM amp. Then cut the wires of the harness and connect them to the corresponding speaker outs of the MS-8 and Kenwood amp. Remember, the harness is there primarily to keep you OEM wiring untouched and to make connections easier, since the wires are already labeled.
__________________
Mobridge DA2 > JBL MS-8 > ARC XDi 600/4 > JBL Gti 408 Mids & Vifa OT19 Tweeters; PG Ti2 1600.5 > Morel HCW-10 & IDMax 15
|