Quote:
Originally Posted by AlanAZ
I coated the new gasket with engine oil before installing for a better seal.
I cut the top off a harder plastic (Arrowhead) clean 1 gal water container, and notched it so I could undo the drain plug with large flat-blade screwdriver, and half filled it with coolant (1/2 gal -- the system takes about 2 gals), and put the plug back in. This was enough so I didn't spill coolant removing the gasket.
Before I put the oil filter back into the housing, I poured a little new oil into the area where I removed it on the de-install to prime it. I also scheduled to do it a couple of days before a regular oil change.
There another tread if you haven't seen it: http://www.e90post.com/forums/showthread.php?t=632565
|
Okay thanks, I was just going to drain as much coolant as possible and refill with new coolant. going to do this on saturday. got my gasket from ECS tuning! woot