I double checked cable config and set the timeout to 1ms. There was no buffer options other than that available.
I also turned my JB4 stage 2 to map 0 which bypasses the CAN control as well.
still getting errors.
Here is what happens.
1. I select profile, and load.
2. I select E89
3. I select CAS
4. Error comes up
In INPA same I get errors as well.
1. load INPA
2. select E90 (F9)
3. select airbag module
4. I get an error.
I have attatched the log from NCS expert
__________________
JB4 Stage 2 | Injen CAI | BMW PE | AR Catless DP | Alpina TCU Flash | Eibach Pro Kit | Custom TCKline Koni's | 19" M359 Wheels | DWS Tires
|