Everything is not quite right....
I did the retrofit and FINALLY got the coding correct. I see the FLA module in INPA and I can dump the trace file in NCS Expert.
I also get the HBA icon on the instrument panel, and the instruments react as they should.
However my car is throwing codes related to the K-CAN bus and after clearing the codes I am getting:
E0C4 - K-Can Bus Cable Fault - High Beam
E2C4 - Bus Low error rate / CAN physical error
E2D4 - DTC unknown fault
Does this mean I have my camera wires reversed?
Thanks!
BTW: Your steps in this thread helped A LOT with the programming.
|