BMW 3-Series (E90 E92) Forum - View Single Post - Aquamist flow sensor 806-428

Chefcg1 · 10-10-2012, 01:56 PM

yes it was the original meth kit with the on/off keyfob. Yeah I literally just took the in power wire and spliced it into the out 12v power, ground was already split so no need to cut out. I took out the old Labonta FS and made a new harness and attached it to the aquamist sensor. That was the extent of the wiring. I turned the adjustment screw all the way counter clockwise on the aquamist sensor and then set injection mode to "0" and injection % to 30%. I tested the system by priming it on the labonte controller and it worked.

I'll drop the injection % to 0 like i had it before when i was running without the FS and see if that gets it to come on.
Thanks, Chuck

10-10-2012, 01:56 PM	#113
Chefcg1 Major 69 Rep 1,137 Posts Drives: 2008 BMW 335i Join Date: Apr 2009 Location: Mount Airy, NC iTrader: (6)	yes it was the original meth kit with the on/off keyfob. Yeah I literally just took the in power wire and spliced it into the out 12v power, ground was already split so no need to cut out. I took out the old Labonta FS and made a new harness and attached it to the aquamist sensor. That was the extent of the wiring. I turned the adjustment screw all the way counter clockwise on the aquamist sensor and then set injection mode to "0" and injection % to 30%. I tested the system by priming it on the labonte controller and it worked. I'll drop the injection % to 0 like i had it before when i was running without the FS and see if that gets it to come on. Thanks, Chuck __________________ 2008 335i coupe AW 6AT, RB Turbos, PROcede 2.5 V5, Alpina Flash, Injen Intake, VK MW DP . Helix IC, Vishnu PnP Meth(M10 nozzel), M3 sides, OEM Aero Lip, VMR V710 Midnight Blue, LUX H8, HID Fogs, M3 front bits, D2 Coilovers, Whiteline Rear Bushing inserts, Custom M3 Steering Wheel, Cyba scoops, M2 Performance Exhaust
	Appreciate 0 Quote