So basically, I need to connect my connectors from the paddles to the two empty slots from the multi-function connector? Now from here, do i need to run two seperate wires to the center consule to connect to the switchgear?
without a DIY thread, this is somewhat confusing but I'm going to give it a try anyways
Quote:
Originally Posted by AlanIOW
Here is a pic of the multi function connector, you will see 2 unused connections [ There are no contacts inside, you will have to buy or make them up from computer connectors]
Craig - The multi function switch does not use normal switchgear I think they have a circuit that changes resistance so the 8 switches only need 4 wires - I am sure it could be done, but I did not want to alter anything permanently.
|