Quote:
Originally Posted by ska325xi
So basically, I need to connect my connectors from the paddles to the two empty slots from the multi-function connector? Now from here, do i need to run two seperate wires to the center consule to connect to the switchgear?
without a DIY thread, this is somewhat confusing but I'm going to give it a try anyways
|
Hi
I know it looks confusing, but once you start dismantling Dave and my photos should make it clearer.
The wires to the centre consoleneed to come from the back of the Slip Ring where there is a multi pin connector.
Make sure before you go much further that your slip ring has the same number of connectors as in Posts 21,22,and 23 I think some early models could be different.
Alan