Quote:
Originally Posted by snoozee
I've not touched the MOST distribution block. but from the retrofit guide, it says to swop the fiber optic cables which in this case will be as follows
LOWER block BOTTOM #2 move to UPPER block BOTTOM #1
UPPER block BOTTOM #1 (MULF cable) move to LOWER block BOTTOM #2
please label all your cables properly before swopping in case you need to reverse the changes
|
I don't see how that gets the MULF into the loop. Doesn't the MULF have an input and an output? If so, then both need to be in the loop.