|
As far as I know, boost is controlled by whichever is targeting higher. E.g. If the procede targets 20 but the dme targets 18 then the boost will be controlled by the procede and vice versa.
I have tested this to some degree as I had my procede targeting 15-16psi in map 1 but it would hit 18-19 due to the flash load targets.
What I haven't tried though is what happens if the Cobb flash targets higher than 20psi. As the procede overboost limit is maxed out at 20psi in the firmware normally it will start to pull WGDC to reduce boost but if it's not controlling boost I don't know exactly what will happen. I.e. Whether it will try and close the throttle to reduce the overboost. I guess maybe I could reduce the procede overboost delay reaction to something obscene like 20 seconds which would maybe stop it from reacting in any way.
I might try and test this out at lower limits and see what happens.
|