Some of them are a little off, like the first two that start off @ 3500rpm, this was back when i knew crapshit about dynos. The last one is the one thats got me puzzled. According to Dustin its boost oscillation, hope it goes away.
First: Stock
Second: PROcede 1.47 & Catback
Third: PROcede V2, CAI, Catback
Fourth: PROcede V2, DCi Fully Catless, but on a catted map. (Wrong Map)
Fifth: PROcede V2, DCI, Fully Catless (Right Map)
Sixth: PROcede V3, DCI, Fully Catless, Stage 2
Seventh: (For Shits and Giggles) The First Limp Mode Dyno
Couple of notes on the various dynos:
- The limp mode was induced because of excessive torque values, nothing else. This was not included as a bash on Vishnu, just to get a laugh. Sometime people ask "whats a limp mode?" well, it pretty much turns your 335 into an '84 Volkwagon Rabbit.
- The V3 Dyno was done with no adaptation, did the V2 dyno and cooled off, uninstalled V2 and installed V3.
- No sims were installed on the V2, so yes i had a check engine light, but no limp.
- Cooling could have been better.
- Both Catless Dynos (V2 & V3) were done on stock torque settings.
- Both Catless Dynos were done today with 62% humidy.
Needless to say i wasnt exactly jumping for joy, but was not dissappointed either. Will be back in a few weeks.