So I dynoed my car a 07 AT today on a Dynojet 224XLC. I wanted a baseline before I installed DP's and FMIC. I only have the JB4 and DCI install. I am running a 50/50 mix. I was hoping to Break 400 but only hit 382.3 rwhp and 439.0 rwtq.
The Dyno only had a small fan so heat soak was a issue. I did a total of 7 pulls. 1 in 3rd gear to check everything out then 5 in 4th gear on map 5 and 1 in 4th gear on map 0 for a baseline. AS A NOTE I HAVE A DINAN STG2 Flash that was on the car when I bought it used so the "baseline" is high.
I have a VRSF FMIC and DP on order and will dyno again to see the gains.