Quote:
Originally Posted by wdlfbio
We picked up the wife's car at the end of the year and I bought a bunch of Zaino products but only used the Z7 so far. So, tomorrow I'm planning on doing a full detail. I just want to make sure what I'm planning is right. These are teh prodcuts I have, Z2, Z5, Z6, Z7, ZFX, and Z18.
So, here's the plan -
1) dawn
2) clay bar, using Z7 in a spray bottle as lubricant
3) wash with either dawn again or Z7
4) Z2 with ZFX
5) Z6
6) Z5 with ZFX
7) Z6
8) Z2 with ZFX
9) Z6
My understanding is the ZFX combined with the Z2 or Z5 will allow me to get everything done in a day.
It's space grey, so does it matter if I go with Z2 or Z5? Zaino recommends ending with the Z2.
Thanks folks.
|
Few comments:
No need to dawn twice. 2nd wash can be with Z7.
I would layer the Z5P first and then 2 layers Z2P on top instead of alternating. Z5P is better as a base since it acts as a polish too.
Z7 as a spary lubricant is fine. I personally think it gets expensive to use Z6 as a claybar lubricant.
Everything else looks good. Good luck!